Adding a preprocessor definition to the build command
Posted by Yoni Davidson on 04 May 2014 02:28 PM

Adding a preprocessor definition from cl command line is possible by adding the "/cl_add" option to your build command in the following way:
/cl_add=”/D DEFNAME=VALUE”
This actually adds the specified parameter to the cl command line when executed. /D stands for “define” option (see cl /? Help for details).

This statement is equivalent to writing “#define DEFNAME VALUE” in the source.

(1 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako