Knowledgebase: IncrediBuild for Linux > Technical Support
Managing the cache
Posted by Yoni Davidson on 02 April 2018 02:17 PM
Introduction:
Cache size and location are specified at installation time. The whole cache is a file holding the file system inside that mounted using loopback device.
Therefore, there is no need to monitor it in order to prevent filling of the disk since the file will always remain in the same size. In addition, IncrediBuild cleans the cache automatically when needed.

Manual cache clean:
The cache clean (if needed) should be performed on every Helper machine. In order to clean the cache in case of a specific problem on the Helper machine, use the following command:
sudo rm --rf --one /ib/mnt/fscache

Important:
It is NOT recommended to clean the cache before consulting with our Support since empty cache may result in low performance.
(0 vote(s))
This article was helpful
This article was not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako incredibuild.kayako.com